I obtained my clear corners through Ebay for around $23. The installation took about 15 minutes total. I replaced the bulbs while I was in there: yellow side marker bulb, hyperwhite cornering bulb. This is probably the easiest install that is possible. It is cheap too, if you know where to look.

The first step is to remove the screw on top of the headlight assembly which holds the corner light in place. (shown below; top left)

The second step is to pull the lens out of the fender. There is a clip near the bottom front of the lens on the side towards the engine. The back is held in by clips that just slide into place. (shown below; top right)

The third step is to unplug all of the bulbs and harnesses, and reattatch to the new lens. If you are replacing the bulbs, now would be the best time. (shown below; bottom left)

Now just reverse the process for removal to put everything back. (shown below; bottom right)

Piece of cake...right!?

Back to Modifications